Steakhouse Grill Knob Replacement Guide

 WARNING!

Potential for electric shock exists for grills if knobs are not replaced. To reduce the risk of electric shock, always follow all repair instructions. Never use or power on the grill without the knobs being permanently installed! 

REPAIR KIT CONTENTS

 

REMOVING THE EXISTING KNOBS

 WARNING!

Product should be powered off and unplugged from the outlet before replacing knobs.
1. Place the tip of a thin, flathead screwdriver into the gap between the first knob and the control panel.
2. Slowly insert the tip of the screwdriver under the edge of the knob. Using the nearest screw (A) on the control panel as a pivot point for the screwdriver, gently lift the knob using the screwdriver as a lever until the knob is completely removed.

3. Repeat the steps above for the remaining knob.
4. Make sure to discard both the old knobs, once removed.
 

INSTALLING THE NEW KNOBS

1. Take care to note the position of the tab (B) inside the column (A). Then place a small amount of silicone rubber adhesive on the column at the center of the knob. 
2. Place the support card (D) around the shaft (C) where the previous knob was connected. Align the new knob, with the tab (B) in the column of the knob aligned with the slot in the middle of the shaft (C) on the housing. Press the knob down gently until fully connected.
3. Pull the support card (D) out from under the knob. The knob should now be completely installed.
4. Repeat the steps above for the second knob.

 

VIDEO INSTRUCTIONS